[hpsdr] Where is the power switch on the revision B Board

[Aivars Straupe]

Anupam, I guess you are going in wrong way. You
stated about 12V PS, but there should be, or clear
13.8V, or 12 and 5V separately. And CAREFULLY
check jumper positions against manual. I guess, I
checked it 10 times, before fire up :-) And
voltage pins as well. I used old PC ATX PS, floppy
drive connector went in place on Hermes almost
good. But I do not remember about pins, was they
correct or not. That's not a problem to exchange them.
P.S. I sent it one more time, because didn't find
"only text" ;-)

                                                 
                                                 
                                                 
                                  Aivars.


 1383715522.0