[hpsdr] Help with Penelope external control

[Tim ORourke]

Belay that mates I just remembered I need to supply the OCref!!
Tim 

-----Original Message-----
>From: Tim ORourke <w4yn at earthlink.net>
>Sent: Nov 30, 2013 5:08 PM
>To: "hpsdr at lists.openhpsdr.org" <hpsdr at lists.openhpsdr.org>
>Subject: [hpsdr] Help with Penelope external control
>
>***** High Performance Software Defined Radio Discussion List *****
>
>I have lost the 12 volt reference voltage on pin 25 of Penelope external control connector.
>Checked 2 Penelope's and both are showing 0 volts. I do have 12 volts on the 12 bus pins A1, B1, C1.
>Cannot for the life of me find where OCRef originates, I see that it should be on U18 pin 9 also but 0 volts there as well!
>Phil anyone know where to look???
>Tim w4yn
>
>Tim O'Rourke 
>W4YN at ARRL.Net
>Low Power Amateur Radio Rocks 
>Member of Flying Pigs,ARCI,GQRP,RSGB,ARRL Life Member
>NHRA Life Member
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at openhpsdr.org
>Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>HPSDR web page: http://openhpsdr.org
>Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/


Tim O'Rourke 
W4YN at ARRL.Net
Low Power Amateur Radio Rocks 
Member of Flying Pigs,ARCI,GQRP,RSGB,ARRL Life Member
NHRA Life Member

 1385851564.0