[hpsdr] PwrSDR with Ozy

[Jim Sanford]

Bruce & Joe:
Got it, thanks!
FYI, I intend to use Janus/Ozy with a 2-slot Atlas I picked up somewhere 
to interface to a UHFSDR, which is the IF for my microwave stack:  222, 
903,1293, 2304, 3446,  5763 and 10368.  The last two will be 
double-conversion to obey the IF >= 0.1 RF rule.

73,
Jim
wb4gcs at amsat.org

On 8/4/2014 8:39 PM, Joe Martin K5SO wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
> -ditto.  Thanks Bruce, I was out today.
>
> 73,  Joe K5SO
>
> On Aug 4, 2014, at 6:31 PM, Bruce Beford wrote:
>
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>> Jim-
>> The have been no changes in the hardware. Joe's reminder is that if you are
>> using firmware later than 4May13 in one board, you must use firmware later
>> than that date in ALL the boards on the system. This is because some signals
>> were redefined at that time. The hardware hasn't changed, but the purpose of
>> some of the various signal pins did (defined by the firmware, not the
>> hardware). So- don't mix old board firmware and newer firmware in an
>> Atlas-based system.
>> I hope this helps.
>> Bruce/N1RX
>>
>>> Joe:
>>> I'm a bit confused by the "keep in mind" paragraph.  Does this mean
>>> there is some hardware version at which the firmware splits?
>>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>


---
This email is free from viruses and malware because avast! Antivirus protection is active.
http://www.avast.com


 1407201053.0