[hpsdr] ANAN-100D 10m power output

[Joe Martin K5SO]

Hi Mike, 

I’m confused by your request.  

1) I am using v2.8

2) If you raise the spinner setting you’ll lower the output power, not increase the output power.  

It’s puzzling to me why you aren’t able to get 100W with the setting of 41.5.  I’ll go ahead and test with higher spinner settings but it should decrease the output power if it’s working properly, which I believe is was because when I initially started my spinner setting was in the 44 range, giving me an output of about 88 watts.  The power increased (as expected) when I lowered the setting to 41.5, giving me 100W out. 

Joe K5SO

On Feb 8, 2014, at 8:32 PM, mstangelo at comcast.net wrote:

> Joe,
> 
> Thanks for the report.
> 
> I did check my PA settings. With v2.7 I get 100 watts out on 10 meters wit a spinner setting of 44.1. With v2.8 I get 75 watts out with the minimum setting of 41.5. The others bands are the same with both versions of code.
> 
> If you have time could you downgrade to v2.8 and see if the 10 meter spinner setting chas to be increased to get an output of 100 watts?
> 
> Thanks,
> 
> Mike N2MS


 1391917259.0