[hpsdr] ANAN-100D 10m power output

[mstangelo at comcast.net]

Joe,

Sorry, I fat fingered. Could you downgrade to v2.7 and see if you get 100 watts out with the same 10 meter spinner setting? I get the same power output for both v2.7 and v2.8 except on 10 meters.

I agree with you. The 100D is an awesome rig. Your effotrs are appreciated.

Mike N2MS
----- Original Message -----
From: Joe Martin K5SO <k5so at valornet.com>
To: mstangelo at comcast.net
Cc: hpsdr at lists.openhpsdr.org list <hpsdr at lists.openhpsdr.org>
Sent: Sun, 09 Feb 2014 03:40:59 -0000 (UTC)
Subject: Re: [hpsdr] ANAN-100D 10m power output

Hi Mike, 

I’m confused by your request.  

1) I am using v2.8

2) If you raise the spinner setting you’ll lower the output power, not increase the output power.  

It’s puzzling to me why you aren’t able to get 100W with the setting of 41.5.  I’ll go ahead and test with higher spinner settings but it should decrease the output power if it’s working properly, which I believe is was because when I initially started my spinner setting was in the 44 range, giving me an output of about 88 watts.  The power increased (as expected) when I lowered the setting to 41.5, giving me 100W out. 

Joe K5SO

On Feb 8, 2014, at 8:32 PM, mstangelo at comcast.net wrote:

> Joe,
> 
> Thanks for the report.
> 
> I did check my PA settings. With v2.7 I get 100 watts out on 10 meters wit a spinner setting of 44.1. With v2.8 I get 75 watts out with the minimum setting of 41.5. The others bands are the same with both versions of code.
> 
> If you have time could you downgrade to v2.8 and see if the 10 meter spinner setting chas to be increased to get an output of 100 watts?
> 
> Thanks,
> 
> Mike N2MS



 1391918420.0