[hpsdr] ANAN-100D Angelia_test_v3.9 code

[Joe Martin K5SO]

Hi Brian, 

You’re not asking for much, are ya!  From what I can see it would involve a complete disassembly of the ANAN-100D in order to gain access to the relays themselves on the PA board, and I’ve had the thing for less than a day, hihi.  

Yeah, sure, I’ll look it over and see how much trouble I can get into doing it to check out the possibility for you; if you’re sure you don’t want to dissassemble yours instead, that is!!  

73,  Joe K5SO


On Feb 9, 2014, at 1:42 PM, Brian Lloyd wrote:

> On Sun, Feb 9, 2014 at 1:37 PM, Joe Martin K5SO <k5so at valornet.com> wrote:
> ***** High Performance Software Defined Radio Discussion List *****
> 
> Thanks, Bruce.  Great to hear it!
> 
> When doing the calibration one thing I noticed that surprised me is that gain is not consistent. Used to be on my ANAN-100D and ANAN-10 that gain was steadily lower going from 160m to 6m. I now have some bumps where not expected, e.g. the PA gain is higher for 15m than for 17m.
> 
> Hmm, the relay drivers for the PA BPF are a pair of TPIC6B595 shift registers. That means that it would be possible to shift in two bits and select two of the BPF in parallel. That might have a significant effect on the passband ripple. Can you confirm that only one bit gets loaded into the shift register?
> 
> -- 
> Brian Lloyd, WB6RQN/J79BPL      
> 706 Flightline Drive
> Spring Branch, TX 78070
> brian at lloyd.com
> +1.916.877.5067

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20140209/1f594dce/attachment-0004.htm>