[hpsdr] Fwd: Problems control Alex

[Joe Martin K5SO]

Jean Marie, 

Just to be clear on how the testing was done here:  

1) Connect Mercury 1 input BNC connector to the “To Rx” BNC connector on your Alex filter set for Mercury 1.  

2) Select Alex on the main menu of PowerSDR, select HF on the band select menu. 

3) Put a signal into Ant1, select Ant 1 in Setup > Alex > Antenna, tune to the signal freq on the main menu, signal shows on panadapter display

4) Put a signal into Ant2, select Ant 2 in Setup > Alex > Antenna, signal shows on the panadatper display

5) Put a signal into Ant 3, select Ant 3 in Setup > Alex > Antenna, signal shows on the panadapter display

6) Put a signal into Rx 1, select Rx 1 in Setup > Alex > Antenna, signal shows on the panadapter display

7) Put a signal into Rx2, select Rx 2 in Setup > Alex > Antenna, signal shows on the panadapter display, 

8) Select VHF on the main menu of PowerSDR and repeat 1) through 7) above, same panadapter display results should occur.  

73,  Joe, K5SO



 1392323226.0