[hpsdr] No modulation from Penelope.

[Kjell Karlsen]

Hi Georg.

Yes, both jumpers must be set. I must have misunderstood some information.

73, Kjell


På Thu, 27 Feb 2014 10:41:17 +0100, skrev georg Prinz <getpri at t-online.de>:

> ***** High Performance Software Defined Radio Discussion List *****
>
> Hi Kjell and all,
>
> that is curious, because on my penelope both jumpers J10 and J11 are set  
> and everything is
> performing without any problems.
>
> 73, Georg, DL2KP
>
>
>
> Am 27.02.2014 09:48, schrieb Kjell Karlsen:
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>> Hi all.
>>
>> Thank you all for different suggestions!
>>
>> The problem was solved by Dough, W5WC (as usual)!
>>
>> It seems as I have missed (or forgotten)some information. I think I was  
>> told some time ago that the I2C jumpers on Penelope should be removed  
>> due to some changes on the Atlas bus. I did this on both of my Penelope  
>> boards. When they was reinstalled, Penny works OK.
>>
>> 73, Kjell.
>>
>>
>>>
>>> On 2/26/2014 9:03 AM, Kjell Karlsen wrote:
>>>> ***** High Performance Software Defined Radio Discussion List *****
>>>>
>>>> Hi all.
>>>>
>>>> I have tested my "old" OpenHPSDR transceiver with Metis, Mercury,  
>>>> Penelope and Munin installed. Everything is working OK except when I  
>>>> try to modulate, nothing is coming out of Penelope. I can use the  
>>>> 2-tone generator to set the Gain By Band in a normal way, if I use  
>>>> TUNE, there is a carrier, if I select AM and push PTT, there is a  
>>>> carrier with correct level but no modulation. In SSB, when using PTT,  
>>>> I see nothing on the spectrum monitor.
>>>>
>>>> I have updated the firmware in all units to the latest (Metis v2.6b,  
>>>> Mercury v3.4, Penelope v1.8.) PSDR is mRX PS v3.2.9 (2/23/14) And  
>>>> Yes, I deleted .......
>>>>
>>>> Georg, DL2KP reported the same problem to me when I asked. When he  
>>>> tried to use Setup, Hardware Config, Orion Hardware setup and  
>>>> selected PTT ON, he get normal modulation. After that, all is OK on  
>>>> his transceiver. I have also tried this but it is not working here. I  
>>>> have tested both of my Penelope units.
>>>>
>>>> ??????
>>>>
>>>> 73, Kjell
>>>>
>>>
>>>
>>> ---
>>> This email is free from viruses and malware because avast! Antivirus  
>>> protection is active.
>>> http://www.avast.com
>>>
>>>
>>
>>
>
>


-- 
Sendt med Operas e-postklient: http://www.opera.com/mail/

 1393495506.0