[hpsdr] kind of Hermes back to open source version
Marc Lalonde
mlalonde at alphatronique.com
Tue May 6 07:20:18 PDT 2014
Hi All
i planing to make new version of hermes and relase it under open source
license
that include Schematic ,PCB and Gerber
that not intended to be a copy of the current design but improved
version whit many change
and naturally put it back on open source community ,and of course fit
my own radio need ;-)
for now that list of change ..
Hermes "Phenix"
1-) swap FPGA for BGA and bigger Version for better routing of high
speed signal
2-) add another LPC2208 ADC (still to determined for that revision what
to avoid to play to much on FPGA )
3-) redo power supply section and power distribution use OKI DC-DC +
local TI Hight PRSS LDO
4-) rempace 10mhz OSC circuit by Copermicus GPS module or FGPMMOPA6H +
MNEA and 1PPS to FPGA for time
5-) add bufferised 122.88Mhz clock for DEMI xverter LO
6-) isolate some input / output ( probably all)
7-) metal can for RF analog section , one for TX one for RX
8-) ADC in LVDS or cmos soft selectable ,LVDS = less noise since
balenced and matche lenght
9-) redo micrel PHY section from scratch whit newer PHY chip and bigger
Volt isolation Jack
10-) bufered 10MHZ ouptut for Kuhne Xverter or sililar use
11-) swap 0805 part for 0603 and QFN for some IC (DAC better routing )
12-) max 6 layer board 100% hand routed
13-) may remove the audio section for simplify not yet sure for this one ..
for now 40% of schematic was done and planing to complete it in next 10
day
take bit long since i work whit PDF Hermes schematic and i find many
error on it to ..
next week-end will try to find place were put file
bit about myself ,Marc Lalonde VE2-OLM was hamradio since 1992 whit
advence license ,
was Senior IPC Certified PCB Designer whit > 20 year experience in high
speed circuit
i own and operate Alphatronique Inc. that a Design house whit in house
SMT Automated Assembly line
for last 10 year most of my job was as subcontractor Design/Assembly
for GE Smart Grid
have absolutely no interest to start a radio company since my current
position was FUN ,RELAX , and LUCRATIVE
so what to keep it as is
so if some one have suggestion of feature to implement it time before i
close shematic
Best 73!
VE2OLM
More information about the Hpsdr
mailing list