[hpsdr] ANAN-100 sometimes no TX after upgrade to 2.9b/3.0 and 3.2.19

[Mike Seguin]

You're right Joe. As I recall there is one filter switching issue. Much 
better to have the PTT out working again with CW so my ACOM linear 
switches correctly than worry about a few watts out.

Tnx,
Mike

On 10/31/2014 5:12 PM, Joe Martin K5SO wrote:
> Mike,
>
> HPSDR Hermes v3.0 will work on your ANAN-100 with respect to fixing the external PTT input and external PA control via the acc’y jack is concerned.
>
> As with previous releases, the HPSDR-released firmware will work fine with many ANAN-series 100 radios in all respects too.  Some specific ANAN-series radios may exhibit a bit lower than max specified output Tx power on one of the HF bands (10m if I recall correctly) if the Apache-Labs-modified version is not used, that’s all.  This slight difference has been discussed at length previously and if your radio makes the required power output for you on the HF bands then there is certainly no reason to wait to load a modified v3.0 firmware on your ANAN-100 radio.
>
> 73, Joe K5SO
>
> On Oct 31, 2014, at 2:49 PM, Mike Seguin wrote:
>
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>> Hi Joe,
>>
>> I see the PTT out issue was fixed on 8/9/14 Tnx!
>>
>> I hope Abhi can release vers 3.0b for ANAN-100 soon.
>>
>> Mike, N1JEZ
>>
>

-- 

73,
Mike, N1JEZ
"A closed mouth gathers no feet"

 1414790123.0