[hpsdr] Exceeded power of Penelope: 630mw

[Joe Martin]

Hi Tokio, 

It is possible that your database.xml file has been corrupted, causing Setup > PA Settings by band to be in error.  You can test whether this is so by deleting the database.xml file and letting the HPSDR PowerSDR program build a fresh one for you.  If there is no change in your symptoms the original database.xml file was likely fine.  

Rather than deleting the database.xml file you might simply drag it to the desktop temporarily from the folder in which it resides, so you can put it back into the original folder later if you find that the file was not causing your problem.  

73, Joe K5SO

On Dec 31, 2015, at 1:35 PM, ENDO Tokio wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> Hi All,
> 
> At the end of 2015, I encountered a problem of Penelope.
> Suddenly the Penelope began to put a power exceeding 500mw, around 600mw.
> However 80meters, 40meters bands are OK with around 230mw accroding to the
> set-up I used to use.
> From 20 meters band up this exceeded power is observed even after I
> re-installed pof.file of version 1.8.
> My Penelope is EU made Penelope I purachased several years ago.
> 
> Any suggestion to rectify this problem is welcomed.
> 
> 73,
> 
> Tokio Endo
> JA1CCA


 1451594810.0