[hpsdr] Exceeded power of Penelope: 630mw

[Joe Martin]

Hi Tokio, 

RR, understood.  Thank you for the clarification.  Yes, I agree with you; it sounds like a fault on the EU Penelope board in this case.  

73, Joe K5SO

On Dec 31, 2015, at 2:16 PM, Tokio Endo wrote:

> Hi Joe,
> 
> Thank you very much for your prompt reply. I didn't detail enough this phenomenon. I replaced this problematic Penelope card by TAPR Penelope without any change of PowerSDR, then the output power becomes quite satisfied. Therefore any setting of PowerSDR would not be a cause and the problem would reside on the Penelope card as well. My question may be which parts of the Penelope board I have to change. 
> 
> Regards,
> 
> Tokio
> JA1CCA
> 
> 2016/01/01 5:46、Joe Martin <k5so at k5so.com> のメッセージ:


 1451597031.0