[hpsdr] broken Hermes board

[K4KV]

Helmut,

It has been so long since I programmed a Hermes, that my memory is not 
clear.

 From what I remember, only the JTAG programmer is required if you have 
a brand new, blank
eeprom.  Else, I should not need the JTAG, just place a jumper(J12?).  
Since this was a working board
I am assuming the eeprom is programmed....

73

Glen K4KV

On 3/14/2017 03:37, Helmut wrote:
> Hi Glen,
>
> please see  http://svn.tapr.org/repos_sdr_hpsdr/trunk/Hermes/Documentation/
>
> You'll find the 'Startup Hermes V1.1' there, describing the two step job.
> Software is on  http://openhpsdr.org/download.php
>
> 73, Helmut, DC6NY
>
>
> -----Ursprüngliche Nachricht-----
> Von: Hpsdr [mailto:hpsdr-bounces at lists.openhpsdr.org] Im Auftrag von K4KV
> Gesendet: Dienstag, 14. März 2017 03:45
> An: hpsdr
> Betreff: [hpsdr] broken Hermes board
>
> ***** High Performance Software Defined Radio Discussion List *****
>
> Hello,
>
> I bought a Hermes that was damaged from Doug(Apache) and am going to
> replace the FPGA.
>
> I know a lot of work has been done on the programmer software, but I
> cannot find it.  It does not
>
> seem to be on the openhpsdr site.  The last dates show 2015, and I
> believe, according to Teamspeak,
>
> that Dave KV0S has released programming software recently.
>
> ???
>
> 73
>
> Glen K4KV
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>