[hpsdr] OpenPowerSDR v3.4.9 60m Tx Filter Problem?

[Jeffrey Gray]

What bandwidth are you using for 60 meters? 2.8k is the max for 60 meters.

On Sun, Apr 15, 2018 at 5:10 PM, Al Pawlowski <k6avp at almont.com> wrote:

> ***** High Performance Software Defined Radio Discussion List *****
>
> Moving from 60m to any other band causes the 60m transmit filter max to
> reset to 2.9kHz. This happens even if the settings are saved as a profile
> before moving and then the saved profile is open after moving back. It is
> pretty annoying to have to reset the 60m tx filter each time, especially
> using WSJT-x, since PowerSDR turns off for filter max. greater than 2.8kHz
> and that causes WSJT-x to stop/quit too. A warning of filter too high would
> be much better. Not forgetting previous settings would be good. A tx filter
> setting of max deviation (of tx signal), instead of just channel width
> (which I would rather see match the receive filter settings) would be
> really nice.
>
> I think 60m tx filter forgetting problem has been around in earlier
> versions too - I do not remember it being in Thetis, but have not run it
> for about 6mo’s.
>
> I am running with an ANAN-100B and Windows 10pro.
>
>
>
> Al Pawlowski, K6AVP
> Los Osos, CA USA
>
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/
> listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20180415/11b75572/attachment.html>