[hpsdr] HPSDR PTT problem

[Dominique DEHAYS]

Hi Ron ,

 

tnx for info. It cannot be a problem of pin contact on the break out board , as it is OK with MOX , in my opinion it is a software problem ,, pity to program a special output for this.

 

There are several others problem associated with PTT , sometimes , the microphone paddle does not work , one has to activate MOX once to get it back to normal behaviour , but in my opinion the tune button problem is more urgent as there is some TX RF going into the rx side components of the transverter , as it is not switched on TX.

73

Dom

 

 

 

 

> Message du 20/11/18 03:59
> De : "Ronald Cox" 
> A : hpsdr at lists.openhpsdr.org
> Copie à : 
> Objet : [hpsdr] HPSDR PTT problem
> 
> ***** High Performance Software Defined Radio Discussion List ***** I have the same setup, ANAN-10 with three Kuhne Electronics Transverters and the breakout card on the back. 1. Make sure the breakout caed is plugged in correctly, you should not see pins exposed on either side of the connector on the rear of the ANAN-10 and make sure the connector is fully seated. 2. If you still can’t get it to work correctly, you can program one of the band select outputs to come on as a substitute PTT signal. Ron W9KFB _______________________________________________ HPSDR Discussion List To post msg: hpsdr at openhpsdr.org Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org HPSDR web page: http://openhpsdr.org Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20181120/18d522c5/attachment.html>