[hpsdr] Atlas Based HPSDR - CW

[Hans J Smit]

Thanks Ram VU3RDD, and Peter DK7SP and Jim WB4GCS,
for replies to my Atlas/CW question!
Of course I should have looked in the right manual...
73, Hans VK5YX


On 12/5/20 7:33 pm, Ramakrishnan Muthukrishnan wrote:
> Hello Hans,
>
> The CW key would go into the DB9 connector of Ozy.
>
> Pin 5 is ground. Pin 6 is dash, 7 is dot and 8 is PTT.
>
> Once you wire up a paddle in this form, put powersdr into CWL/CWU mode
> and you will see the CW options on the panel and you can adjust speed
> etc. It is also available from within the configuration options menu.
>
> I use a bencher BY1 paddle with it (exactly your setup -
> ozy/merc/penny/atlas -- and it works great.
>
> 73
> Ram VU3RDD
>
> On Tue, May 12, 2020 at 2:24 PM Hans J Smit <hansvk5yx at bigpond.com> wrote:
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>> I've recently become interested in (better) learning and using CW.
>> The radio in question is the most basic 2008 Atlas-Penelope-Mercury-Ozy
>> system.
>> It's a great CW receiver using the latest PowerSDR.
>> Where is a straight Morse key or paddle best connected to enable CW
>> transmit?
>> 73 & thanks for any help!   Hans VK5YX.
>> _______________________________________________
>> HPSDR Discussion List
>> To post msg: hpsdr at openhpsdr.org
>> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>> HPSDR web page: http://openhpsdr.org
>> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>