[hpsdr] GIBRALTAR Wiki Update
peter at gehughes.us
peter at gehughes.us
Sat Jul 15 18:56:18 PDT 2006
Hi Rick,
Will either oscillator mount on the GIBRALTAR or was that still a design
choice?
The Crystek Oscillator says it runs off +15 Vdc..
Are there provisions to generate +15Vdc since ATLAS only supplies +/-
12Vdc
Or will it just be run off +12VDC or does that make the V-F an easier
choice.
Peter Hughes
N7BMG
> -------- Original Message --------
> Subject: Re: [hpsdr] GIBRALTAR Wiki Update
> From: Lyle Johnson <kk7p at wavecable.com>
> Date: Sat, July 15, 2006 7:30 pm
> To: "Rick Hambly (W2GPS)" <w2gps at cnssys.com>
> Cc: hpsdr at hpsdr.org
>
> ***** High Performance Software Defined Radio Discussion List *****
>
> Hello Rick!
>
> > I have updated the GIBRALTAR Wiki page, including a preliminary block
> > diagram. I encourage comments.
>
> Since you asked...
>
> 1) Are the Synchronous Divider, Oscillator Steering and Quantization
> Correction intended to be mostly subsumed into an FPGA? IF so , the 1
> PPS and 10 MHz drivers tot he ATLAS backplane can likely fit into the
> same FPGA.
>
> 2) Would the GPS receiver be better tied to ATLAS for its communications
> instead of, or in addition to, a local USB interface?
>
> 3) Based on the notes at the bottom of the page, I vote for the V-F
> OCXO: less power consumption for the same approximate cost.
>
> 4) There have been some suggestions that one or two user-programmable
> output frequencies be provided on Gibraltar, such as 20 MHz or 12.288
> MHz. Are you thinking of adding these, or not including them?
>
> I'm anxious to test this!
>
> 73,
>
> Lyle KK7P
>
> Guess I'd better get on the stick with Sasquatch!
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at hpsdr.org
> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
> HPSDR web page: http://hpsdr.org
> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
1153014978.0
More information about the Hpsdr
mailing list