[hpsdr] It Works!

[Bill Tracey]

Not sure the SDR 1000 needs to be powered up before initozy.bat is 
run -- can't think of any reason for that.  Initozy.bat does nothing 
to the SDR 1000 - all it does is load the FX2 firmware,  initialize 
the FPGA and do some initialization of the TLV320AIC23B codec via the I2C bus.

The SDR 1000 does need to be powered up before you you launch 
PowerSDR -- PowerSDR.exe does some initialization of the SDR 1000 
hardware when it starts.

Regards,

Bill (kd5tfd)


At 07:01 PM 5/30/2007, Joe - AB1DO wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>Hi Pete,
>
>Interesting thing is that after your message I explicitly ran initozy.bat
>without the SDR-1000 turned on everything went fine - completely normal
>initialization with no errors.
>
>For what it's worth,
>73 de Joe - AB1DO
>
>Peter Thompson wrote:
>
>
><snip>
> >
> > There were some initial problems with initozy.bat - running this with
> > atlas powered-up but the SDR-1000 connected but NOT powered-up produced
> > lots of errors but gave the impression it was configured.  On then
> > powering the rig and running PowerSDR, kept getting odd behavior such as
> > PowerSDR going into Xmit.  Redoing ozyinit with the SDR-1000 powered-up
> > seems to fix this.  Maybe the docs should be explicit about what to turn
> > on and when.
> >
><snip>
> > Pete, N3EVL



 1180579113.0