[hpsdr] up and running

[Bill Tracey]

Unless you're running Phil's Mercury 2 beta FPGA code on the Mercury, 
you have to use 192000 sampling since the code loaded in the shipping 
boards only supports 192000 sampling.

Not remembering the setting is a known problem and is fixed in the 
last bit of code I released (26-Dec-2008a I believe)

Re: Only being able to run at 48000 --  two things to try.  First, 
decrease the "Main Display FPS" on  Setup->Display.  Second, try 
higher "Process Priority"  on  Settup   -> General -> Options.

Regards,

Bill

At 08:45 AM 12/29/2008, Ken wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>Just a note to say I got my unit running, after some fiddling with 
>the libusb driver.
>
>The first time I started Ozy, the "found new hardware" wizard wanted 
>to run. Stopping it was a mistake as the FPGA load program went into 
>a loop throwing off "unhandled exception" errors.
>
>The second time, I let the hardware wizard to its thing and, after a 
>couple of reboots/restarts, everything started working fine.
>
>I found I had 2 OZY Host devices showing in device manager - I was 
>able to remove the first one.
>
>My little 2.53 GHz/533 MHz Pentium 4 can only run at 48000 sampling 
>rate (50% CPU load) - higher rates result in dropouts.
>
>>>It seems that Power SDR does not want to remember that I have 
>>>selected 48k and always comes up with 192k when restarted.
>
>= = = = = =
>Thanks to all involved in making this possible.
>
>Ken
>KE2N
>
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at hpsdr.org
>Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
>HPSDR web page: http://hpsdr.org
>Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/



 1230564124.0