[hpsdr] Testing Penelope

[Roland Etienne]

Graham,

Thanks for the info, I was wondering how I could do CW with Penelope! So 
Ozy can support a keyer, but I cannot find where are the inputs and I 
wonder if I can connect a simple straight key?

73,Roland f8chk.

Graham / KE9H a écrit :
> Roland:
>
> I have also seen this happen when you set the PowerSDR for HPSDR,
> but did not go into
>
> SetUp>DSP>Keyer
>
> and assign the Keyer to Ozy.  If the keyer is
> still assigned to SDR here, it can also go into transmit mode.
>
> --- Graham / KE9H
>
> ==
>
>
> Roland Etienne wrote:
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>> I had no time to test Penelope before, so I am now trying to use it 
>> before Mercury's arrival...
>> I usually run the SDR 1000 with Ozy-Janus without any problem.
>> To test Penelope on a dummy load, I have only Ozy (slot 5) and 
>> Penelope (slot 4) in Atlas, and no connection with the SDR 1000.
>> Running the last PowerSDR modified (svn 2573), with title bar "KD5TFD 
>> 26 Dec 2008 a) PowerSDR v1.10.1 + Base SVN 2025".
>> I have checked HPSDR Hardware as radio model, and only Penelope as 
>> hpsdr board.
>> When I start PowerSDR, Ozy firmware is loaded, leds on Penelope are 
>> ok, but Power SDR go immediately in TX mode and no hf is coming out 
>> from Penelope!
>>
>> Thanks for help, and season's greetings to everyone!!
>>
>> 73, Roland f8chk.
>>
>>
>>
>>
>> _______________________________________________
>> HPSDR Discussion List
>> To post msg: hpsdr at hpsdr.org
>> Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
>> HPSDR web page: http://hpsdr.org
>> Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/
>>
>
>
>


 1230584617.0