[hpsdr] Operating Penelope without Mercury Board

[Bill Tracey]

Try it with Janus Ozy as the sound card and not the M-Audio.  With 
the M-Audio set as the sound card PowerSDR is sending the xmit data 
there.  If you select Janus/Ozy it will send it to Janus/Ozy and the 
FPGA code on Ozy will send the data to Penny.

Regards,

Bill (kd5tfd)

At 07:49 PM 10/19/2008, Ronald Cox wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>I have checked out my Penelope, Ozy and Janus boards as much as
>possible without a SDR-1000 or SoftRock 40 and I get the D9 an D10
>alternating LEDs showing Ozy was initialized properly, and when I
>select the M-Audio sound card as the sound card in PowerSDR, all my
>transmit waveforms look correct on the screen, but the RF is not there
>at the BNC connector.  Is there a way to check out the transmit RF
>signals without a Mercury board?
>
>Ron, W9KFB
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at hpsdr.org
>Subscription help: http://lists.hpsdr.org/listinfo.cgi/hpsdr-hpsdr.org
>HPSDR web page: http://hpsdr.org
>Archives: http://lists.hpsdr.org/pipermail/hpsdr-hpsdr.org/



 1224478506.0