[hpsdr] Penelope Firmware Upgrade: "Programming hardware cable not detected"

[Kjell Karlsen]

Hi Jack.

Yes, JP7 (Last JTAG) is the one you found.

73, Kjell




På Thu, 05 Aug 2010 21:51:13 +0200, skrev Jack Speer <speerj at buck.com>:

> ***** High Performance Software Defined Radio Discussion List *****
>
>
> Hi,
>
>    I have a Penelope board purchased from a gentleman in Germany on  
> eBay.  I'm having trouble programming it.  After picking "B.  Program  
> using Penelope_v1.2" (which I assume is right?) I get the message  
> "Error:  Programming hardware cable not detected"
>
>    I've tried this with Quartus 9.1sp2 and Quartus 10.0.
>
>    One possibility, the HPDSRWiki instructions refer to placing a jumper  
> on JP7 on Penelope, but there are no jumper markings on my board.  From  
> a fuzzy photo of another Penelope my best guess is JP7 was at the lower  
> left corner of the FPGA, is that correct?
>
>
> Thanks,
>
> Jack, N1BIC
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:  
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>


-- 
Sendt med Operas revolusjonerende e-postprogram: http://www.opera.com/mail/

 1281039013.0