[hpsdr] Penelope Firmware Upgrade: "Programming hardware cable not detected"

[Jack Speer]

   Good, glad to know that's the right one.

   Does anyone have any ideas on the error 
message?  Penelope is dead in the water until I 
can figure out what's causing the error.


73,

Jack, N1BIC


At 04:10 PM 8/5/2010, Kjell Karlsen wrote:
>Hi Jack.
>
>Yes, JP7 (Last JTAG) is the one you found.
>
>73, Kjell
>
>
>
>
>På Thu, 05 Aug 2010 21:51:13 +0200, skrev Jack Speer <speerj at buck.com>:
>
>>***** High Performance Software Defined Radio Discussion List *****
>>
>>
>>Hi,
>>
>>    I have a Penelope board purchased from a gentleman in Germany on
>>eBay.  I'm having trouble programming it.  After picking "B.  Program
>>using Penelope_v1.2" (which I assume is right?) I get the message
>>"Error:  Programming hardware cable not detected"
>>
>>    I've tried this with Quartus 9.1sp2 and Quartus 10.0.
>>
>>    One possibility, the HPDSRWiki instructions refer to placing a jumper
>>on JP7 on Penelope, but there are no jumper markings on my board.  From
>>a fuzzy photo of another Penelope my best guess is JP7 was at the lower
>>left corner of the FPGA, is that correct?
>>
>>
>>Thanks,
>>
>>Jack, N1BIC
>>
>>_______________________________________________
>>HPSDR Discussion List
>>To post msg: hpsdr at openhpsdr.org
>>Subscription help:
>>http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>>HPSDR web page: http://openhpsdr.org
>>Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>>
>
>
>--
>Sendt med Operas revolusjonerende e-postprogram: http://www.opera.com/mail/


 1281103727.0