[hpsdr] Stupid question re PowerSDR+Janus+SoftRock

[Murray Lang]

Unfortunately the W5WC version is the same - no obvious way to set the 
centre frequency when HPSDR+Janus is the hardware selection.
Is anyone out there using a SoftRock+Janus+PowerSDR setup?

73,
Murray VK6HL

On 18/12/2010 9:27 PM, Murray Lang wrote:
> ***** High Performance Software Defined Radio Discussion List *****
>
> Hi Roland,
>
> I have the KD5TFD version (17 Dec 2010). This has no centre frequency 
> setting when HPSDR and Janus are selected. I'll have a look for a W5WC 
> version - thanks.
>
> Murray VK6HL
>
> On 18/12/2010 8:39 PM, roland etienne wrote:
>> Hi Murray,
>>
>> I suppose you are using W5WC version of Power sdr, in wich case the 
>> center
>> frequency can be set in the setup, General, Hardware config tab.
>>
>> And if your Softrock RxTx is using a SI570, with this version of 
>> PowerSDR
>> you can command the SI570 via Ozy, you just need to wire the I2C 
>> correctly.
>>
>> Hope this helps,
>>
>> 73, roland F8CHK.
>>
>>
>>
>>> -----Message d'origine-----
>>> De : hpsdr-bounces at lists.openhpsdr.org [mailto:hpsdr-
>>> bounces at lists.openhpsdr.org] De la part de Murray Lang
>>> Envoyé : samedi 18 décembre 2010 13:19
>>> À : hpsdr at lists.openhpsdr.org
>>> Objet : [hpsdr] Stupid question re PowerSDR+Janus+SoftRock
>>>
>>> ***** High Performance Software Defined Radio Discussion List *****
>>>
>>> Hi all,
>>>
>>> I've finally got around to trying to set up Janus with my SoftRock TXRX
>>> but have been stumped by a most basic and necessary requirement: How do
>>> I tell PowerSDR the centre frequency of my SoftRock? The document 
>>> "Janus
>>> and Ozy Operation with PowerSDR" mentions the SoftRock but does not 
>>> even
>>> contain the word "frequency". I can't find any reference on the web to
>>> this problem so it's either bleeding obvious or nobody is using 
>>> PowerSDR
>>> with Janus and a SoftRock (hard to believe).
>>>
>>> At this stage I would be very pleased to have my poor investigative
>>> skills laid bare in return for an answer.
>>>
>>> 73,
>>> Murray VK6HL
>>>
>>> _______________________________________________
>>> HPSDR Discussion List
>>> To post msg: hpsdr at openhpsdr.org
>>> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-
>>> openhpsdr.org
>>> HPSDR web page: http://openhpsdr.org
>>> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>>
>>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: 
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>


 1292681736.0