[hpsdr] Transverter setup

[Kevin Wheatley]

Hi Alfred

From my VERY limit knowledge with the PSDR code, I believe the bandplan (TX enabled) is via the database. If this assumption is correct then you only need to modify the database and thus enabling Tx on 22Mhz.

I'm sure others will chip in if I'm pushing you in the wrong direction. No real problem trying :)

73's
Kevin
On 17 May 2010, at 19:41, Alfred Green wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> I didn't see any comments, so I'll ask again. Maybe everyone was enjoying themselves at Dayton!
> 
> My homebrew 222 and 432 transverters have non-standard IFs, both come down at 22MHz. PSDR realizes that this is out of band, and won't allow transmit. With my SDR1000 and PSDR 1.18.3, if I set up the transverter form, and go to the VHF+ tab all is well.
> 
> Because of the number of spurs in that part of the band I want to use the hpsdr system, which is very clean.
> 
> All comments gratefully received.
> 
> 73  Alf
> 
> Alfred Green wrote:
>> ***** High Performance Software Defined Radio Discussion List *****
>> 
>> I'm in the process of migrating my VHF/UHF+ transverters from my SDR1000 to my hpsdr stack
>> When I go to the XVTRs tab and select 'Enable' nothing happens. The rest of the line stays greyed out.
>> With PSDR 1.18.3 that I use with the SDR1K and F3K, when the line is enabled it allows entry in the other fields for LO offset, gain, etc.
>> 
>> I've hunted through the Setup, but don't see what I've missed.
>> 
>> I'm running PSDR 1.10.4  svn 2025.
>> 
>> Any ideas?
>> 
>> 73  Alf  NU8I
>> Scottsdale  AZ  DM43an
>> _______________________________________________
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/


 1274122119.0