[hpsdr] Fwd: Alex

[Chris Smith]

Hi Jim

This is what I was told about the cables back in October.

The order page mentions the SMB coax being supplied with the TX board plus the VSWR cable. I think that about covers the cabling.

Cheers & 73

Chris G4NUX

Begin forwarded message:

> From: Graham / KE9H <KE9H at austin.rr.com>
> Date: 11 October 2010 13:19:42 GMT+01:00
> To: Chris Smith <chris at vspl.co.uk>
> Cc: HPSDR Reflector <hpsdr at openhpsdr.org>
> Subject: Re: [hpsdr] Alex
> 
> Chris:
> Answers inline, below.
> 
> 
> On 10/11/2010 3:49 AM, Chris Smith wrote:
>> ***** High Performance Software Defined Radio Discussion List *****
>> 
>> Hi
>> 
>> When Alex becomes available will the assembled&  tested board(s) come with a ribbon cable for the SPI bus ready assembled or will this be up the the purchaser to supply?
> The ribbon cable will be part of the total kit.  Connects to Mercury on the other end.
>> Also what form does the "Rx In (Internal)" to "Out to RX (Internal)" take? Is it coaxial?
> Coaxial, with SMB connectors
>> Does the Fwd/Rev power sensor data go via the SPI ribbon?
> Yes, and a separate four pin connector, also.
> 
> --- Graham
> 
> 
> 
> ==
>