[hpsdr] dual mercury - diversity19 / oscillations

[Georg Prinz]

Joe,

I am using Metis v1.1, Mercury 1= v6.4 and Mercury 2 = v6.4.

Georg



Am 14.03.2011 22:54, schrieb Joe Martin K5SO:
> ***** High Performance Software Defined Radio Discussion List *****
>
> Georg,
>
> This suggests that the IQ data for logical Merc 2 is being passed 
> incorrectly or inserted incorrectly for some reason, while Merc 1 IQ  
> data is correct.   Please verify that these are the firmware versions 
> that are being reported on the Setup > HPSDR menu:
>
> Ozy FX2: 2009 05 24
> Ozy: 6.3
> Mercury 1: 6.4
> Mercury 2: 6.4
>
> Yes?
>
> Joe K5SO
>
> On Mar 14, 2011, at 3:29 PM, Georg Prinz wrote:
>
>> ***** High Performance Software Defined Radio Discussion List *****
>>
>> Hello Joe,
>>
>> now I know, why I didn't observe it earlier. I always used mercury 1 
>> only. Now I connected my antenna via splitter to both boards. The 
>> effect is always on mercury2 and therefore in diversity mode, too.
>>
>> I swaped the addresses between the two boards (jumpers on J5: booard 
>> 1: 3,2 = Channels_8_1 bit; board 2: 3,2=Channels_8_1 bit and  5,4 = 
>> mercury ID bit 0) and the error remained on mercury 2. This shows, 
>> that it is not linked to the board.
>>
>> I am using excalibur as clock-source!
>>
>> Does this help for further investigation?
>>
>> Vy 73, georg - dl2kp
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: 
> http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>


 1300140380.0