[hpsdr] Penny V1.4 firmware issue (tracked down problem but not sure where to go next)

[Joe Martin K5SO]

For reference, when I do this suggested test on my system the monitor  
audio is clean and sounds fine in both cases.

73,  Joe K5SO

On Sep 19, 2011, at 6:57 PM, Phil Harman wrote:

> Hi Paul,
>
> You may want to try this.
>
> With PennyLane  selected, and the Drive level set to zero, monitor  
> your Tx
> signal using the MON function via the latest version of W5WC's  
> PowerSDR
> code.
>
> Then do the same but select Penelope this time and see if it is still
> distorted.
>
> Since the mic audio paths in the FPGA are identical in each case it  
> will
> indicate if the distortion is in the FPGA code or PC code.
>
> I'm about to release new versions of all FPGA code to support the new
> relay switching frequencies and manual relay selection for Alex.
>
> 73 Phil...VK6APH
>


 1316482261.0