[hpsdr] 10 Mhz Input Jack

[Bruce Beford]

Hello, Tokio.
It is my plan to use a DPDT switch to change both jumper settings together.
I have not had time to do this yet. However, that is my intention at this
time.
73,
Bruce, N1RX

-----Original Message-----
From: tokio.endo2 at i.softbank.jp [mailto:tokio.endo2 at i.softbank.jp]
Sent: Friday, November 30, 2012 7:16 PM
To: Bruce Beford
Cc: <hpsdr at lists.openhpsdr.org>
Subject: Re: [hpsdr] 10 Mhz Input Jack

Hi Bruce,

To alter 10MHz clock  source, we need to change jumpers J20 and J23 at the
same time.
Do you use a toggle switch for both jumpers?
I  also would like to alter the clock source and I'm thinking how I change
two jumpers by switch or relay.

Tokio
JA1CCA

2012/11/28 8:07、"Bruce Beford" <bruce.beford at myfairpoint.net> のメッセージ:

> ***** High Performance Software Defined Radio Discussion List *****
>
> Not a menu entry, but you must set the appropriate jumpers on the board to
> disable the on board clock an enable the external jack. See the Hermes
> operating manual. As these jumpers are not accessible once in an enclosure
> like the ANAN-10, I intend to add a toggle switch to mine to be  able to
> easily switch back and forth.
> 73,
> Bruce, N1RX
>
>> To use the 10 Mhz external clock jack on the back of Hermes - is
>> there any special menu settings needed to activate it?  I have a GPS
>> Clock receiver with a 10 Mhz output.  Have the TAPR Hermes board
>> and Anan-10 PA and enclosure.  Using version .21 PowerSDR (W5WC)
>> Hermes 1.8
>
>
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help:
http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/




 1354323296.0