[hpsdr] Metis down

[Scott Cowling]

Hi Issac,

Do the power indicator LEDs D1, D2, D3 and D10 light? If none of them 
light, then there is likely a short on the +5V input to the board (or 
maybe +5V is missing on the Atlas backplane?)

If +5V is missing, this would also prevent Mercury from coming up.

Do you have a USB Blaster?

73,
Scotty WA2DFI

At 20:10 2013-10-02 +0300, Isaac Weksler wrote:
>***** High Performance Software Defined Radio Discussion List *****
>
>Hi, all.
>
>Advice needed.
>I have ordered a Metis board from TAPR and got it about 2 weeks ago.
>Programmed it by the latest firmware 2.6b (Metis_v2.6b.rbf) using
>Bootloader. It worked fine for about a week. Then a few days ago, it failed
>to start - no LEDs lighting when the power is applied. Tried to program it
>again using Programmer - no board detected. Same result with the Bootloader
>(JP1 and JP2 in place).
>Any advice will be highly appreciated.
>
>73 Isaac 4Z1AO
>
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at openhpsdr.org
>Subscription help:
>http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>HPSDR web page: http://openhpsdr.org
>Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
>
>_______________________________________________
>HPSDR Discussion List
>To post msg: hpsdr at openhpsdr.org
>Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
>HPSDR web page: http://openhpsdr.org
>Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/




 1380738390.0