[hpsdr] Angelia_v2.0 firmware and new output_file.pof file

[Clyde Washburn]

There is room just to the right of the Ethernet jack on the anan-100d front panel to install a small toggle switch to jumper j17
without opening the unit -- that was my solution.

Clyde, K2UE

-----Original Message-----
From: hpsdr-bounces at lists.openhpsdr.org [mailto:hpsdr-bounces at lists.openhpsdr.org] On Behalf Of Joe Martin K5SO
Sent: Tuesday, September 17, 2013 7:59 AM
To: mstangelo at comcast.net
Cc: hpsdr list
Subject: Re: [hpsdr] Angelia_v2.0 firmware and new output_file.pof file

***** High Performance Software Defined Radio Discussion List *****

Hi Mike, 

Sorry to hear you're having trouble.  Here are my suggestions: 

1) Run the HPSDSRProgrammer program, under Device select "Hermes", then click on the "Hermes Bootloader" tab. 

2) Browse to the Angelia_v2.0.rbf file (there is no .rtf file).  

3) After putting J17 on your Angelia board, power cycle the Angelia board to ensure that things come up properly for programing the
EEPROM (ethernet cable connected, of course). 

4) Click on "Program"

I like your idea of extending the J17 jumper connection on the ANAN-100D.  I use a standalone Angelia board here so access isn't a
problem for me but I'd certainly extend the connection if I had an ANAN-100D.

If these steps don't work for you I suggest that we work together via direct email (off reflector) so that we will be able to pass
screen shots to each other.  That way perhaps we can more easily find out what's going on with your particular system.  

73,  Joe K5SO


On Sep 16, 2013, at 7:31 PM, mstangelo at comcast.net wrote:

> Joe,
> 
> I am trying method 2 usingHPSDRProgrammer -- for W5WC and K5SO -2012-12-8-Rev 3
> 
> I select Hermes device - Hermes Boot Loader, Browse for the .rtf file and select Program
> 
> I then get an Error: cannot open interface (are you running as root). Operating system is Windows XP. I'm logged in with my
account which is set as administrator.
> 
> I found a 2 pin plug that fits onto J17. I intend to run the cable from this plug out a rear vent hole so that I can easily short
J17 in the future.
> 
> Mike N2MS

_______________________________________________
HPSDR Discussion List
To post msg: hpsdr at openhpsdr.org
Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
HPSDR web page: http://openhpsdr.org
Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/


 1379431704.0