[hpsdr] Angelia_v2.0 firmware and new output_file.pof file

[Joe Martin K5SO]

Even better! 

73,  Joe K5SO

On Sep 17, 2013, at 9:28 AM, Clyde Washburn wrote:

> There is room just to the right of the Ethernet jack on the anan-100d front panel to install a small toggle switch to jumper j17
> without opening the unit -- that was my solution.
> 
> Clyde, K2UE
> 
> -----Original Message-----
> From: hpsdr-bounces at lists.openhpsdr.org [mailto:hpsdr-bounces at lists.openhpsdr.org] On Behalf Of Joe Martin K5SO
> Sent: Tuesday, September 17, 2013 7:59 AM
> To: mstangelo at comcast.net
> Cc: hpsdr list
> Subject: Re: [hpsdr] Angelia_v2.0 firmware and new output_file.pof file
> 
> ***** High Performance Software Defined Radio Discussion List *****
> 
> Hi Mike, 
> 
> Sorry to hear you're having trouble.  Here are my suggestions: 
> 
> 1) Run the HPSDSRProgrammer program, under Device select "Hermes", then click on the "Hermes Bootloader" tab. 
> 
> 2) Browse to the Angelia_v2.0.rbf file (there is no .rtf file).  
> 
> 3) After putting J17 on your Angelia board, power cycle the Angelia board to ensure that things come up properly for programing the
> EEPROM (ethernet cable connected, of course). 
> 
> 4) Click on "Program"
> 
> I like your idea of extending the J17 jumper connection on the ANAN-100D.  I use a standalone Angelia board here so access isn't a
> problem for me but I'd certainly extend the connection if I had an ANAN-100D.
> 
> If these steps don't work for you I suggest that we work together via direct email (off reflector) so that we will be able to pass
> screen shots to each other.  That way perhaps we can more easily find out what's going on with your particular system.  
> 
> 73,  Joe K5SO
> 
> 
> On Sep 16, 2013, at 7:31 PM, mstangelo at comcast.net wrote:
> 
>> Joe,
>> 
>> I am trying method 2 usingHPSDRProgrammer -- for W5WC and K5SO -2012-12-8-Rev 3
>> 
>> I select Hermes device - Hermes Boot Loader, Browse for the .rtf file and select Program
>> 
>> I then get an Error: cannot open interface (are you running as root). Operating system is Windows XP. I'm logged in with my
> account which is set as administrator.
>> 
>> I found a 2 pin plug that fits onto J17. I intend to run the cable from this plug out a rear vent hole so that I can easily short
> J17 in the future.
>> 
>> Mike N2MS
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
> 


 1379433295.0