[hpsdr] Dumb Questions

[Joe Martin K5SO]

I see that the items I called caps below are actually inductors with plastic covers over them, on the newer picoPSUs; but that’s a nit. 

Joe K5SO

On Apr 16, 2014, at 12:02 PM, Joe Martin K5SO wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> Michael, Warren,
> 
> The Hammond 1455Q enclosure is what I use here (from DigiKey) for my Angelia board, and that’s what I’ve been calling the Hermes enclosure (perhaps inappropriately).  My picoPSU fit without requiring any grinding, but I notice that some of the later picoPSUs have two larger caps on the side now that make them a bit wider than the earlier versions so perhaps that’s what you have.  I did grind a portion of a few of the internal rails near P1 and P2 to make it easier to plug and unplug blaster cables.  
> 
> 73, Joe K5SO
> 
> On Apr 16, 2014, at 11:48 AM, Owen, Michael wrote:
> 
>> Joe-
>>  
>> My Angelia was purchased stand-alone.  I can't vouch for it fitting in a Hermes enclosure because I don't have one, but Angelia + PicoPSU does fit in a Hammond 1455Q. It is a tight fit, however.  The outside of the PicoPSU is just a couple of millimeters too wide.  I had to grind some slot rails off the inside end of the Hammond enclosure.
>>  
>> W9IP
>>  
> 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20140416/461c1e5e/attachment-0004.htm>