[hpsdr] Angelia_v2.7 firmware ... "fix" for using ANAN-100D with HPSDR Programmer

[Joe Martin K5SO]

Hi Norbert, 

Very good!  This is helpful to me.  From your test result: 

> Programmer V2 nopcap (2.0.4.5) can erase flash and program 2.7 into Angelia, Angelia is up and running 

You ARE able to use HPSDR Programmer to load firmware if Angelia_v2.8 is in your board.  Otherwise you cannot.  That is you can go from v2.8 to v2.7 but you cannot go back to v2.8 if v2.7 is in your board.  

Some folks seem to be able to go from v2.7 to v2.8 with the programmer and a few cannot, but EVERYONE it seems (from the reports so far, at least) are able to use HPSDR Programmer to load a firmware version as long as Angelia_v2.8 is in the board.  

Thus, I think we should revise our previous statement to say that as long as Angelia_v2.8 or later is in the ANAN-100D then HPSDR Programmer will work.  If anything earlier than v2.8 is in the ANAN-110D HPSDR Programmer may or may not work.  

We’ll see if anyone has results that differ from the above statement.  

73,  Joe K5SO
 
On Feb 8, 2014, at 8:57 AM, dl8laq at sh-home.de wrote:

> ***** High Performance Software Defined Radio Discussion List *****
> 
> Hi Joe, 
> I did a longer test: 
> Direct connection via LAN from Angelia to pc. Programmer doesn't work via my switch (gigabit switch ZyXel GS-105b V2).
> cuSDR & PSDR are working fine
> Programmer V2 nopcap (2.0.4.5) can erase flash and program 2.7 into Angelia, Angelia is up and running 
> And now update to 2.8 from installed 2.7
> Programmer 2.0 discovers Angelia with 2.7
> Erasing flash, waiting for >3 minutes, no programming
> PSDR cannot connect to Angelia 
> Used boot loader to install 2.8 again, Angelia is up and running 
> Programmer flashed 2.0a into Angelia
> 2.0a and 3.2.1 are doing something, but not very nice :-)
> Programmer cannot flash back to 2.8, used bootloader instead
> Angelia is up and running 
> A 2nd try with programmer from 2.7 to 2.8 failed! 
> 73, Norbert 
> Joe Martin K5SO schrieb: 
>> ***** High Performance Software Defined Radio Discussion List ***** If anyone else who is experiencing that Angelia_v2.7 does not work properly with HPSDR Programmer can do the test below for me I’d appreciate hearing of the result, as I can’t reproduce the problem here but would like to know if HPSDR Programmer works for you when Angelia_v2.8 is in your ANAN-100D. 
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/


 1391875838.0