[hpsdr] ANAN-100 sometimes no TX, after upgrade to 2.9b/3.0, and 3.2.19

[Mike Sch. (IMAP Acct.)]

Hello, and I THANK YOU for your reply and comments!

On the Apache web site, I was only able to locate firmware and PSDR 
versions 3.0 and 3.2.19.  This is where I downloaded the newest versions 
from, when I upgraded from from my previous 2.2 and 3.2.17 to 2.9, then 
3.0 and 3.2.19.

I was able to locate firmware versions 2.5, 2.7 and 2.9 on the Yahoo 
user group web site.

I downloaded them all, just so I'd have them all on hand.

I just installed firmware 2.7, and without a restart, the "sometimes 
no-RF issue" has apparently gone away!!!  (So I am now running 2.7 and 
3.2.19, at this point.)

I have just restarted the computer, and I will see if the issue is still 
allowing my PTT actions to result in a CONSISTENT RF OUTPUT every time I 
press the PTT.  (I am hopeful!)

So, I am wondering if I _re-applied firmware 3.0_, would this fresh load 
possibly resolve the issue..?  Going back to 2.7 sure has made a change, 
for some reason!  Also, many, MANY folks have been running 3.0/3/2/19 
with total satisfaction and success, so I feel that the products, as 
presented, and just fine!

73;   -Mike-   K0JTA


On 10/29/14, 4:23 PM [Oct 29], hpsdr-request at lists.openhpsdr.org wrote:
> As you have an ANAN radio you must use the firmware downloaded from the Apache web site, not the OpenHPSDR web site.
> If you used the firmware from OpenHPSDR I doubt this explain your problem.
>
> Jean-Claude Abauzit PJ2BVU

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20141029/5cac559a/attachment-0002.htm>