[hpsdr] ANAN-100 sometimes no TX, after upgrade to 2.9b/3.0 and 3.2.19

[Mike Sch. (IMAP Acct.)]

Helmut;

I thank you for your reply to my plea for assistance!!

No, the "Disable PTT" is not checked.  If this was checked, I'd NEVER be 
able to transmit via my mic's PTT, as you know.

You see, the PTT ALWAYS WORKS AS EXPECTED when I press the PTT on my 
mic.  (The radio goes to TX mode, just sometimes it emits no RF power.)

Only at times, there is NO RF that is being produced by the radio. (This 
happens one out of every ten times, maybe...)

I will add that my ANAN-100's VOX seems to never have the "no RF power 
output, when the PTT is pressed in SSB mode" issue!!  Maybe this is a 
clue to someone?

Thank you again, and very 73!   -Mike-   K0JTA



On 10/29/14, 12:24 PM [Oct 29], Helmut wrote:
> Hi Mike,
>
> no special recommendations from my side, but I have never seen the issues
> you are describing. The current FW v.3.0 ( I also used a Beta test version
> before) together with PowerSDR mRX 3.2.19 works absolutely fine in my Hermes
> environment. Are you really sure that you did not check e.g. PTT 'disabled'
> under setup/options? In that case PTTout is working, but no RF will be
> transmitted.
>
> 73, Helmut, DC6NY
>
> -----Ursprüngliche Nachricht-----
> Von: Hpsdr [mailto:hpsdr-bounces at lists.openhpsdr.org] Im Auftrag von Mike
> Sch. (IMAP Acct.)
> Gesendet: Mittwoch, 29. Oktober 2014 17:14
> An: hpsdr at lists.openhpsdr.org
> Betreff: [hpsdr] ANAN-100 sometimes no TX, after upgrade to 2.9b/3.0 and
> 3.2.19
>
> ***** High Performance Software Defined Radio Discussion List *****
>
>


 1414606687.0