[hpsdr] Boot loader for DFC Firmware

[ad0es]

That worked.

For the record, its the "Board Bootloader" menu (2nd down), "Test for 
Bootloader" button.

The bootloader position of the switch is to the left (LED/connector) 
side of the radio.
The normal position is to the right side.

On 07/30/2017 12:58 PM, Scott Traurig wrote:
> You use the "Board Programmer" section.
>
> Get out your Sharpie. Power cycle the radio. Try discovery with 
> Bootloader. If it works, mark the position of the switch. If it 
> doesn't, move the switch, cycle radio power, try discovery again. It 
> should work that time. Mark the position of the switch.
>
> --Scott
>
> On Sun, Jul 30, 2017 at 2:50 PM, ad0es <ad0es at ad0es.net 
> <mailto:ad0es at ad0es.net>> wrote:
>
>     ***** High Performance Software Defined Radio Discussion List *****
>
>      I found:
>
>     https://github.com/TAPR/OpenHPSDR-SVN/blob/master/KV0S/hpsdr-programmers/Release/HPSDRBootloader-debian-64.tar.gz
>     <https://github.com/TAPR/OpenHPSDR-SVN/blob/master/KV0S/hpsdr-programmers/Release/HPSDRBootloader-debian-64.tar.gz>
>
>     Which seems to talk to the anan, find its MAC and read its IP address
>
>     What is the appropriate jumper position on the bottom of the
>     anan200D for programming, like an idiot I moved it back
>     and forth without recording the original position.
>
>     Which menu do I use for Bootloader mode,
>
>     Board Programmer,
>     or
>     Use board as a jtag programmer.
>

-- 
Steve AD0ES

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20170730/0c493a90/attachment.htm>