[hpsdr] Thetis v2.8.11 with Hermes.

[Helmut Oeller]

Hallo Martin,

no new finding, but not less annoying and/or confusing. I think the bug
will be deleted soon. BTW, this time I used Thetis only under protocol
1. No knowledge if this issue also exists under protocol 2 mode.

Take it easy as Hermes will NEVER deliver 35 or 40 watts, hi.

73, Helmut, DC6NY



Am 08.11.2020 um 13:42 schrieb Martin Emmerson:
> ***** High Performance Software Defined Radio Discussion List *****
>
>
> Has anyone, using this combination, noticed that on TX the Thetis Fwd
> Pwr shows about 35W?
> This is with the General -> H/W Select -> Hardware - Alex box unticked
> so this should not
> happen.
> Also get over SWR warnings which can be stopped by unticking SWR
> protection in the Alex
> tab but Alex should not be active with its box unticked?
> After some investigation I found the following line of code in setup.cs:
> //    console.AlexPresent = chkAlexPresent.Checked;
> Removing the "//" from the start of the line and recompiling the code
> has resolved the problem!
> I cannot see any reason this line has been commented out? as the
> checkbox is there to
> enable/disable Alex.
> I realise that most people won't notice this, especially those that
> have Alex or equivalent.
> However a friend G3KOM who is going to use his Hermes to drive a 2m
> transverter was rather
> concerned about this erroneous power output reading...
>
> I wonder if anyone can tell me why the Alex tickbox has been rendered
> inactive?
>
> Thanks
>
> Martin G3OQD.
>
> _______________________________________________
> HPSDR Discussion List
> To post msg: hpsdr at openhpsdr.org
> Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
> HPSDR web page: http://openhpsdr.org
> Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20201108/66e3f874/attachment.html>