[hpsdr] external 10MHz reference input
dave powis
g4hup at btinternet.com
Wed May 22 12:01:05 PDT 2013
You could also look at http://g4hup.com/DA/DA.htm. Available as kit or built and tested
73,
Dave, G4HUP
________________________________
From: Chris Wilson <chris at chriswilson.tv>
To: hpsdr <hpsdr at lists.openhpsdr.org>
Sent: Saturday, 18 May 2013, 22:13
Subject: Re: [hpsdr] external 10MHz reference input
***** High Performance Software Defined Radio Discussion List *****
> ***** High Performance Software Defined Radio Discussion List *****
> Hi Bert,
> RR, understood.
> Here I use a TAPR TADD distribution amp between my Rb-vapor freq
> standard output and the ext 10 MHz input on my radios. Perhaps you
> need a bit more in terms of drive for the ext 10 MHz input on your Hermes boards?
> Keep in mind the 3.3v limit on
the board devices, as has been mentioned.
> Good luck!
> 73, Joe K5SO
18/05/2013 22:12
Hi Joe, can you tell me if these distribution amps are still
available? I am now at a point where I have more test gear and stuff
than I can realistically daisy chain from my Trimble Thunderbolt GPS
locked source without a distribution amp. I seem to recall seeing this
was discontinued, but not sure. Thanks!
--
Best Regards,
Chris Wilson.
_______________________________________________
HPSDR Discussion List
To post msg: hpsdr at openhpsdr.org
Subscription help: http://lists.openhpsdr.org/listinfo.cgi/hpsdr-openhpsdr.org
HPSDR web
page: http://openhpsdr.org
Archives: http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.openhpsdr.org/pipermail/hpsdr-openhpsdr.org/attachments/20130522/c117e192/attachment-0004.htm>
More information about the Hpsdr
mailing list